Quantitative analysis of proton exchange membrane prepared by radiation-induced grafting on ultra-thin FEP film

Radiation-induced graft polymerization is introduced to effectively fabricate proton exchange membrane based on 12.5 μm fluorinated ethylene propylene (FEP) film. The graft side chains penetrate FEP film and distribute inside the bulk matrix evenly. The membranes exhibit hydrophilic/hydrophobic microphase-separated morphology as well as good thermal stability. The influences of irradiation parameters on the membrane property are investigated and the resulting membranes (named FEP-g-PSSA) exhibit excellent physicochemical properties. Membrane with 27.48% degree of graft and 130.1 mS cm⁻¹ proton conductivity is employed for fuel cell performance measurement. Under optimized operate conditions (80 °C, 75% relative humidity), the power density could reach up to 0.896 W cm⁻², inspiring for fuel cell application. The mass-transport-controlled polarization of membrane electrode assembly (MEA) based on FEP-g-PSSA membrane is higher than Nafion® 211 within the whole current density range and the gap is widening with increasing current density. At 2.0 A cm⁻², the mass transfer polarization of FEP-g-PSSA reaches up to 0.204 V, far higher than Nafion® 211 (0.084 V). By promoting the compatibility between the ionomer in the catalyst layer and FEP-g-PSSA membrane and optimizing the membrane/catalyst layer/gas diffusion layer interfaces, the fuel cell performance could be significantly enhanced, making the FEP-g-PSSA membranes promising in fuel cell application.