Comparison of the corrosion and cavitation erosion behaviors of the cast and surface-modified manganese-aluminum bronzes in sodium chloride solution

Modified layers with refined and homogenized microstructure were obtained on a cast manganese aluminum bronze (MAB) by friction stir processing (FSP) and laser surface melting (LSM). In 3.5% NaCl solution, a much more protective film was formed and uniform corrosion occurred for the two surface-modified MABs. The corrosion rate of the cast sample was reduced by a factor of 29.73% after FSP and 51.35% after LSM. The cavitation erosion (CE) rate of the cast MAB was about 1.83 and 3.07 times larger than that of the FSP and LSM samples, respectively. The CE resistance increment was highly attributed to the improved hardness and enhanced nano-indentation behavior after FSP or LSM. For each MAB, the CE resistance decreased with extended pre-immersion time. Compared with the result of the correspondingly freshly-prepared sample, the CE rate was raised by a factor of 36.22%, 42.97% and 44.00% after 30 days’ pre-immersion for the cast, FSP and LSM MABs, respectively. For the cast and FSP MABs, mechanical impact was the leading factor accounting for CE degradation. For the pre-corroded samples, corrosion damage at the β and κ phases weakened the mechanical properties and thus triggered more grievous material exfoliation under CE. For the LSM MAB, CE-corrosion synergy dominantly gave rise to the CE damage. Corrosion at grain boundaries after pre-immersion also deteriorated the CE performance. The LSM MAB possessed the highest corrosion and CE resistances because the fine single-phase microstructure reduced the galvanic corrosion effect and crack propagation tendency under CE impact.